|
|
|
| The in-situ system for continuous analysis and oxygen control (O2) |
|
 |
The system is based on: 1- Probe with zirconium oxide sensor,standard length 300/500/700 mm, built-in heater; • Quick response time (less than 5 sec.) for a better air/combustion gases' control. 2- Controller or monitors. • O2 measurement range: 0...21% • Output value 4...20 mA (0...21%O2) • PID trim control for different loads with 4...20 mA analog output (controller) • Direct measure: oxygen,air/flue gases temperature. Calculated measures: combustion efficiency, excess' air, CO2 in the flue gases (calculated in %) For further information please write
to: |